FARO Edge
September 2012
24
Chapter 2: Setup
2 Insert the front edge of the 7-Axis Handle into the slot.
3 Push the 7-Axis Handle in so that the connectors connect.
4 Tighten the locking ring by turning it clockwise. Do not over-tighten the
ring.
N
OTE: Remove the 7-Axis Handle from the Edge before packing. See
“Packing the Edge” on page 30.
Figure 2-15 Attaching the 7-Axis Handle
08M52E00_FaroArm_Edge.book Page 24 Thursday, October 4, 2012 9:31 AM
To Next Page
Loading...
