FARO Edge
September 2012
37
Chapter 3: Operation
See “Hardware Configuration” on page 178.
• The unknown FARO i-Probe warning - This warning appears when a FARO i-
Probe is attached to the Edge and never compensated. For accurate measuring,
you must compensate the probe. Use your measuring software to set up and
compensate the probe. See “Probes” on page 178.
• The missing FARO i-Probe warning - This warning appears when no probe is
attached to the Edge.
• Other errors appear in a message box.
Figure 3-3 Edge stress stop warning
Figure 3-4 Unknown FARO i-Probe warning
Figure 3-5 Unknown FARO i-Probe warning
08M52E00_FaroArm_Edge.book Page 37 Thursday, October 4, 2012 9:31 AM
To Next Page
Loading...
