Safety Notes 19
Others
Locate this product in a well-ventilated area. Do not obstruct ventilation openings of the product.
Keep the minimum clearance as follows for ventilation and an access to the power plug. Unplug the product if
an abnormal condition is noted.
Do not incline the product at more than 10 degree angle. Otherwise, it may fall over and cause injuries.
Always lock the wheels of this product after installation. Otherwise, it may fall over or slide and cause injuries.
Always locate the output unit inside the rack under the scanning unit.
To keep this product in a good performance and condition, always use it in the following environment:
• Temperature: 10 – 32 °C
• Humidity: 10 – 85%
When the product is left in a chilly room and the room is rapidly warmed up by heater, dew condensation may
form inside the product and cause a partial deletion on printing.
930 mm
880 mm
100 mm
320 mm
600 mm 528 mm 400 mm
600 mm 528 mm 400 mm
400 mm
430 mm
197 mm
197 mm
560 mm
Right Left Right Left
Front Back Front Back
10° 10°
10° 10°
To Next Page
Loading...
