Faxing 273
Specifying the Fax Settings Options
This section includes:
• "Changing the Fax Settings Options" on page 273
• "Available Fax Settings Options" on page 273
Changing the Fax Settings Options
1 Press the (System) button.
2 Select the Tools tab, and then select Admin Settings.
3 Select Fax Settings.
4 Select the desired menu item.
5 Select the desired setting or enter the value using the number pad.
6 Select OK to save the selection.
7 Ensure that the message This Setting Becomes Effective after Restart appears, and then press
any button.
8 If necessary, repeat steps 4 to 6.
To return to the top level of the System menu, press the CA (Clear All) button.
Available Fax Settings Options
You can use the following settings options for configuring the fax system:
Option Description
Fax Number Specifies the fax number of the printer, which will be printed on the header of
faxes. This feature is available when you set Send Header to On. The
number specified in Fax Number is used in the printer ID.
Region You can select the region where the printer is used.
You can change this setting when:
• No jobs in operation
• No fax jobs waiting in the memory
Company Name Specifies the sender’s name to be printed on the header of faxes.
Line Type You can select the default line type.
• PSTN
• PBX
Line Monitor Sets the volume of the line monitor, which audibly monitors a transmission
through the internal speaker until a connection is made.
DRPD Pattern Before using the Distinctive Ring Pattern Detection (DRPD) option, distinctive
ring service must be installed on your telephone line by the telephone
company. After the telephone company has provided a separate number for
faxing with a distinctive ring pattern, configure the fax setup to monitor for that
specific ring pattern.
Extel Hook Threshold You can select the external telephone hook detection threshold for the
condition in which a telephone line is not being used.
To Next Page
Loading...
Need help?
General
