90 Printer Connection and Software Installation
Overview of Network Setup and Configuration
To set up and configure the network:
1 Connect the printer to the network using the recommended hardware and cables.
2 Turn on the printer and the computer.
3 Print the System Settings page and keep it for referencing network settings.
4 Install the driver software on the computer from the Driver CD Kit or PostScript Driver Library CD. For
information on driver installation, see the section in this chapter for the specific operating system you are using.
5 Configure the printer’s TCP/IP address, which is required to identify the printer on the network.
• Microsoft
®
Windows
®
operating systems: Run the IP address setting tool on the Driver CD Kit to set the
printer’s IP address if the printer is connected to an established TCP/IP network. You can also manually set
the printer’s IP address on the operator panel.
• Mac OS
®
X and Linux
®
systems: Manually set the printer’s TCP/IP address on the operator panel.
See also:
• "Setting the IP Address" on page 94
6 Print a System Settings page to verify the new settings.
NOTE:
• If the Driver CD Kit or PostScript Driver Library CD is not available, you can download the latest driver from the Fuji Xerox
Web Site: http://www.fujixeroxprinters.com/
See also:
• "Printing a System Settings Page" on page 170
To Next Page
Loading...
Need help?
General
