330 Using the Operator Panel Menus and Keypad
Fax Defaults
Purpose:
To modify the defaults for the Fax menu.
NOTE:
• The FAX service cannot be used unless you set up a region code under Region. If Region is not set up, a message Set
the Country Code appears on the display.
• Values marked by an asterisk (*) are the factory default menu settings.
• Resolution
Purpose:
To specify the scan resolution to improve the output quality.
Values:
NOTE:
• Faxes scanned in the Super Fine mode transmit at the highest resolution supported by the receiving device.
• 2 Sided Scanning
Purpose:
To scan both sides of a sheet of paper.
Values:
*1
This item is available only when 2 Sided Scanning is set to 2 Sided Printing in the Scan Defaults menu.
• Lighten / Darken
Purpose:
To adjust the density to make the copy lighter or darker than the original.
Values:
Standard
*
Suitable for documents with normal sized characters.
Fine Suitable for documents containing small characters or thin lines or documents printed
using a dot-matrix printer.
Super Fine Suitable for documents containing extremely fine detail. The Super Fine mode is enabled
only if the remote machine also supports the Super Fine mode. See the notes below.
Photo Suitable for documents containing photographic images.
1 Sided
*
Scans one side of a document.
2 Sided Binding of
Original
*1
Long Edge
Binding
*
Scans both sides of a document to be bound by long edge.
Short Edge
Binding
Scans both sides of a document to be bound by short edge.
Darken +3 Works well with light print or faint pencil markings.
Darken +2
Darken +1
Normal
*
Works well with standard typed or printed documents.
Lighten +1 Works well with dark print.
Lighten +2
Lighten +3
To Next Page
Loading...
Need help?
General
