294 Using the Operator Panel Menus and Keypad
IPsec
NOTE:
• IPsec feature is available only when IPsec is enabled on the CentreWare Internet Services.
Purpose:
Disables IPsec.
Value:
Reset Wireless
NOTE:
• Reset Wireless feature is available only when the printer is connected using the wireless network.
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network
settings are reset to their default values.
Value:
Connection Speed
NOTE:
• Connection Speed feature is available only when the printer is connected using the wired network.
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the
printer is turned off and then on again.
Values:
Disable Disables IPsec.
Reset Initialize wireless network settings.
Auto
*
Detects the Ethernet settings automatically.
10BASE-T Half Uses 10BASE-T Half-duplex.
10BASE-T Full Uses 10BASE-T Full-duplex.
100BASE-TX Half Uses 100BASE-TX Half-duplex.
100BASE-TX Full Uses 100BASE-TX Full-duplex.
1000BASE-T Full Uses 1000BASE-T Full-duplex.
To Next Page
Loading...
