288 Using the Operator Panel Menus and Keypad
• Paper Select Mode
Purpose:
To set the way to select the paper tray for PostScript mode.The change becomes effective after the printer is turned
off and then on again.
Values:
• Output Color
Purpose:
To specify the color mode to Color or Black and White. This setting is used for a print job which does not specify a
print mode.
Values:
PDF Settings
Use the PDF Settings menu to change printer settings that only affect the PDF jobs.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Quantity
Purpose:
To specify the number of copies to print.
Values:
• 2 Sided Print
Purpose:
To specify whether to print on both sides of a sheet of paper.
Values:
• Print Mode
Purpose:
To specify the print mode.
Values:
Auto* The tray is selected as the same setting as in the PCL mode.
Select From Tray The tray is selected in a method compatible with regular PostScript printers.
Color* Prints in color mode.
Black and White Prints in black and white mode.
1
*
Sets the value in increments of 1.
1–999
1 Sided* Does not print on both sides of a sheet of paper.
2 Sided Binding Edge Long Edge Flip
*
Prints on both sides of a sheet of paper to be bound by long edge.
Short Edge Flip Prints on both sides of a sheet of paper to be bound by short edge.
Normal
*
For documents with normal sized characters.
High Quality For documents with small characters or thin lines, or documents printed using a dot-matrix
printer.
High Speed Prints with the higher speed than the Normal mode, but the quality is less.
To Next Page
Loading...
