256 Faxing
Sending a Fax From Memory
1 Load the document(s) face up with top edge in first into the DADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Loading an Original Document" on page 253
2 Press the (Services) button.
3 Select Fax.
4 Adjust the document resolution to suit your fax needs.
See also:
• "Adjusting the Document Resolution" on page 255
• "Adjusting the Document Contrast" on page 255
5 To select a fax number, do one of the followings:
• Select button, and then select one of the following:
Device Address Book - Individuals - Select an individual fax number and then select OK.
Device Address Book - Groups - Select a group dial number and then select OK.
Search Network Address Book - Search and select a fax number from the LDAP server and then
select OK.
• Select button.
Enter the speed dial number using the number pad, and then select button.
NOTE:
• For more information on address book and server address book, see "Address Book" on page 269.
• If you are using the LDAP server address book, Fax Server Address Book must be set to On. For
details, see "Fax Server Address Book" on page 307.
• The fax number needs to be registered before you can select Address Book.
6 Press the (Start) button.
When the document is placed on the document glass, the display prompts you for another page. If you want to
place a new document, replace the document with a new document, and then select Continue. When you
have finished loading documents, select Send Now.
The printer starts dialing the number, and then sending the fax when the remote fax machine is ready.
NOTE:
• By pressing the (Stop) button, you can cancel the fax job at any time while sending the fax.
To Next Page
Loading...
Need help?
General
