Using the Operator Panel Menus and Keypad 333
• Bypass Tray
Purpose:
To specify the paper loaded in the bypass tray.
Values:
Display Tray
Prompt
Enter a check to display a popup message that prompts to set Type and Size when paper is loaded
in the bypass tray. The factory default is on (check).
Use Driver
Settings for Print
Job
Enter a check to use the Size and Type set on the print driver. The factory default is off (blank).
Size A4 (210 x 297 mm)
*1
mm series A5 (148 x 210 mm)
B5 (182 x 257 mm)
Letter (8.5 x 11")
Folio (8.5 x 13")
Legal (8.5 x 14")
Executive (7.25 x
10.5")
Monarch Env. (3.9 x
7.5")
DL Env. (110 x 220
mm)
C5 Env. (162 x 229
mm)
#10 Env. (4.1 x 9.5")
New Custom Size Width(x) 210 mm
*
Specifies the width of the custom
size paper.
77-215 mm
Length(y) 297 mm
*
Specifies the length of the custom
size paper.
127-355 mm
inch series Letter (8.5 x 11")
*1
Folio (8.5 x 13")
Legal (8.5 x 14")
A4 (210 x 297 mm)
A5 (148 x 210 mm)
B5 (182 x 257 mm)
Executive (7.25 x
10.5")
Monarch Env. (3.9 x
7.5")
DL Env. (110 x 220
mm)
C5 Env. (162 x 229
mm)
#10 Env. (4.1 x 9.5")
New Custom Size Width(x) 8.3 inches
*
Specifies the width of the custom
size paper.
3.0-8.5 inches
Length(y) 11.7 inches
*
Specifies the length of the custom
size paper.
5.0-14.0 inches
To Next Page
Loading...
