304 Using the Operator Panel Menus and Keypad
Fax Protocol
Purpose:
To set whether to print the protocol monitor report, which helps you identify the cause of a communication problem.
Values:
System Settings
Use System Settings to configure a variety of printer features.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• General
Purpose:
To configure general settings for the printer.
Energy Saver
Purpose:
To specify the time for transition to Energy Saver mode.
Values:
When you specify 1 minutes for Low Power Timer, the printer enters energy saver mode 1 minutes after it
finishes a job. This uses much less energy, but requires more warm-up time for the printer. Specify 1 minutes if your
printer shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready to operate
with minimum warm-up time. Select a value between 1 and 60 minutes for Low Power Timer if you want a
balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the Energy Saver mode when it receives data from the
computer or remote fax machine. You can also change the status of the printer to the standby mode by pressing
(Wake UP) button on the operator panel.
Print Always Prints a protocol monitor report after every fax transmission.
Print On Error Prints the protocol monitor report only when an error occurs.
Print Disable
*
Does not print the protocol monitor report.
Low Power Timer 1min
*
Specifies the time taken by the printer to enter Low Power mode
after it finishes a job.
1–60 min
Sleep Timer 4min
*
Specifies the time taken by the printer to enter Sleep mode after
it has entered Low Power mode.
1–6 min
To Next Page
Loading...
Need help?
General
