404 Troubleshooting
035-701 Select Close, or wait for the time set in Fault Timeout for the printer to recover. Check the
following:
• Status of the remote machine
• tone/pulse setting
NOTE:
• For more information on tone/pulse setting, see "Dial Type" on page 302.
035-702 Select Close, or wait for the time set in Fault Timeout for the printer to recover. Try the same
operation.
035-708 Select Close, or wait for the time set in Fault Timeout for the printer to recover. Try the following:
• Try the same operation.
• Reduce the modem speed.
NOTE:
• For more information on modem speed, see "Modem Speed" on page 303.
035-717 Select Close, or wait for the time set in Fault Timeout for the printer to recover. Reduce the modem
speed.
NOTE:
• For more information on modem speed, see "Modem Speed" on page 303.
035-718 Select Close, or wait for the time set in Fault Timeout for the printer to recover. Check the status of
the remote machine.
035-720 Select Close, or wait for the time set in Fault Timeout for the printer to recover. Check the features
of the remote machine.
035-781 Select Close, or wait for the time set in Fault Timeout for the printer to recover. Check if the remote
machine is busy.
042-700 Wait for a while until the printer cools down.
077-215 Turn off the printer. Confirm that the duplexer is correctly installed, and turn on the printer. Contact
customer support if this failure is repeated.
093-925 Turn off the printer. Confirm the black toner cartridge is correctly installed, and turn on the printer.
093-950 Turn off the printer. Confirm the yellow toner cartridge is correctly installed, and turn on the printer.
093-951 Turn off the printer. Confirm the magenta toner cartridge is correctly installed, and turn on the printer.
093-952 Turn off the printer. Confirm the cyan toner cartridge is correctly installed, and turn on the printer.
116-316 Turn off the printer. Remove the optional 512MB memory from the slot, and then reattach it firmly. Turn
on the printer. Contact customer support if this failure is repeated.
116-317 Turn off the printer, and turn it on again. Contact customer support if this failure is repeated.
116-320 Remove the unsupported additional memory module. Contact customer support if this failure is
repeated.
116-721 Select Close, or wait for the time set in Fault Timeout for the printer to recover.
116-722
117-361 Turn off the printer, and turn it on again. Contact customer support if this failure is repeated.
To Next Page
Loading...
Need help?
General
