Fujitsu PRIMERGY BX900 - Port Group Messages

© 2011 Fujitsu Technology Solutions
Severity Level 6
Error Message Can't change DHCP client identifier while DHCP client identifier
mode is not TEXT
Explanation Can't change DHCP client identifier while DHCP client identifier
mode is not TEXT
Recommended Action Change the DHCP identifier to use TEXT mode.
Severity Level 6
Error Message Internal stacking port (S1) is disabled by E-Keying on unit:
<unit-id>
Explanation Internal stacking port (S1) is disabled by e-Keying on unit
<unit-id>
Recommended Action Check the setting from the management blade of BX900 if the
internal stacking is disabled. If you want to stack two connection
blade, enabling the internal stacking link is preferred.
2.31 Port Group Messages
Severity Level 6
Error Message Failed to set isolation mode of intIfNum <intIfNum>
Explanation Can’t apply the isolation function for interface <intIfNum> while
interface is link up.
Recommended Action Send the log to your support agent to find the problem.
Severity Level 6
Error Message portGrpsIntfChangeCallback: Received an interface event
callback while not in EXECUTE state. (event: <event>, state:
<state>)
Explanation portGrps is not ready executed.
Recommended Action Send the log to your support agent to find the problem.
Severity Level 6
Error Message portGrpsPortMirroringCheck: portGrpsMemberRemove: rc=<rc>
Explanation Member be removed from port group failure.
Recommended Action Send the log to your support agent to find the problem.