© 2011 Fujitsu Technology Solutions
2.29 Stacking Messages
This section contains the Stacking Module messages.
Severity Level 6
Error Message Minimum required F/W revision <firmware version> is detected
on unit <unitID>.
Explanation The latest firmware version is found on the stack member.
Recommended Action To upgrade whole stacking to this firmware version from stack
master.
Severity Level 6
Error Message Firmware download on unit <unit-id> is successfully.
Explanation The latest firmware image is updated successfully on unit
<unit-id>
Recommended Action The lastest firmware image is updated successfully.
Severity Level 6
Error Message Firmware auto-upgrade on unit <unit-id> is successfully. Unit
<unit-id> will be reloaded.
Explanation The auto-upgrade process is executed for <unit-id> and unit
<unit-id> device will be reload to apply the upgraded firmware.
Recommended Action To wait the switch to join the stack.
Severity Level 6
Error Message Unit <unit-id> changes booting mode to <switch/IBP>
Explanation Unit <unit-id> changes booting mode to switch or IBP.
Recommended Action A reboot process is required to run the device in new mode.
Severity Level 6
Error Message Version mismatch on unit <unit-id> is detected. Issue the
auto-download processes.
Explanation A FW mismatch version is detected on <unit-id> and the auto
download process is being executed.
Recommended Action During the download process, please do not remove the target
device.
Severity Level 6
Error Message Delete cfg mismatched entry for unit <unit-id>
Explanation A unit is found on the previous entry of configuration mismatched
unit. System will delete this entry and recreate the new one for
current detected unit.
Recommended Action To wait the new unit to join the stack.
To Next Page
Loading...
