© 2011 Fujitsu Technology Solutions
Severity Level 6
Error Message Different type of Connection Blade is detected on stack member
<unit-id>.
Explanation Different type of connection blade is detected on stack member.
Recommended Action Remove this mismatched connection blade from the stack or use
command, “switch <unit-id> bootmode <switch|IBP>” to change
the mode to be the same as the stack master.
After the mode is changed via the provided command, the
mismatched connection blade will be reloaded automatically.
Severity Level 1
Error Message out of stack members, please pull out the cable and make sure
only maximum 8 units in a stack
Explanation The stack member is exceeded max supported number in a
stack.
Recommended Action Remove this connection blade from the stack.
Severity Level 1
Error Message Running code version not available, aborting discovery message
send.
Explanation Can’t find the running code version.
Recommended Action Checking if there is any default booting image in the flash.
Severity Level 1
Error Message Flash code version not available, aborting discovery message
send
Explanation Can’t find the code version in the flash.
Recommended Action Checking if there is any default booting image in the flash.
Severity Level 1
Error Message Problem sending discovery message on unit <unit-id>
Explanation The discovery messages can’t be sent out.
Recommended Action Please check the stacking cable is connected.
Severity Level 1
Error Message Failure while attempting to delete management unit
Explanation Can’t delete the management unit.
Recommended Action Please do not delete the management unit.
To Next Page
Loading...
