Fujitsu PRIMERGY BX900 - Service VLAN

© 2011 Fujitsu Technology Solutions
4.3.5 Service VLAN
This section contains the Service VLAN module messages.
Error Message Error: Failed to set <svcVlanName>. Service VLAN name must
contain alphaNumeric characters only, and can't be empty.
Explanation It is failed to create a Service VLAN Group while the name is not
alphanumeric characters.
Recommended Action Use alphanumeric characters for the Service VLAN Group name
to create a Service VLAN Group and the name can not be
empty.
Error Message Error: Can't set the same VLAN ID on uplink set
<uplinkSetName>.
Explanation The Service VLAN Group can’t use this VLAN ID which is used
by on group with the same uplink set.
Recommended Action Use the different VLAN ID for Service VLAN Group.
Error Message Error: Failed to delete <svcVlanName>.
Explanation The Service VLAN name is invalid.
Recommended Action Refresh the WEB page and select the service VLAN name
again.
Error Message Error: Failed to create Service VLAN. Service VLAN already
exists.
Explanation The Service VLAN already existed.
Recommended Action Create the Service VLAN with a name which is not used in the
system.
Error Message Error: Value <vlanId> is out of range for VLAN ID. The valid
range is 1 to 4094.
Explanation The input VLAN ID of Service VLAN is out of range.
Recommended Action Set the VLAN ID of Service VLAN with numeric character 1 to
4094.
Error Message Error: Interface <interface_identifier> has been used.
Explanation The interface is already used by other Group.
Recommended Action Remove the interface from the other Group or set other interface
to Service VLAN.