© 2011 Fujitsu Technology Solutions
4.4 Security
4.4.1 Port Access Control
This section contains Port Access Control module messages.
Error Message Error: Server Timeout (secs) format is invalid.
Explanation User uses non-numeric characters for Server Timeout.
Recommended Action Use numeric character to configure Server Timeout.
Error Message Error: Value (<value>) is out of range for Server Timeout (secs).
The valid range is 1 to 65535.
Explanation The value of Server Timeout is out of range.
Recommended Action The range for Server Timeout is 1 to 65535.
Error Message Error: Maximum Requests format is invalid.
Explanation User uses non-numeric characters for Maximum Requests.
Recommended Action Use numeric character to configure Maximum Requests.
Error Message Error: Value (<value>) is out of range for Maximum Requests.
The valid range is 1 to 10.
Explanation The value of Maximum Requests is out of range.
Recommended Action To set the value of Maximum Requests in the range of 1 to 10.
Error Message Error: Reauthentication Period (secs) format is invalid.
Explanation User uses non-numeric characters for Reauthentication Period.
Recommended Action To set the value of Reauthentication Period in the range of 1 to
65535.
Error Message Error while trying to initialize port
Explanation User try to Initialize the 802.1x function of a interface, but the
802.1x global Administrative Mode does not enable.
Recommended Action User should enable the 802.1x global Administrative Mode, and
then Initialize the 802.1x interface.
Error Message Error while trying to reauthenticate port
Explanation User try to Reauthenticate the 802.1x function of a interface, but
the 802.1x global Administrative Mode does not enable.
Recommended Action User should enable the 802.1x global Administrative Mode, and
then Reauthenticate the 802.1x interface.
To Next Page
Loading...
