© 2011 Fujitsu Technology Solutions
4.5.2 COS Messages
This section contains the COS module messages.
Error Message Error: Interface Shaping Rate format is invalid.
Explanation User try to configure Interface Shaping Rate with non-numeric
characters.
Recommended Action Use numeric characters for the Interface Shaping Rate.
Error Message Error: Value (<value>) is invalid for Interface Shaping Rate. Valid
range is 0 to 100 in increments of 5.
Explanation The value of Interface Shaping Rate is out of range.
Recommended Action The range of the Interface Shaping Rate is 0 to 100 in
increments of 5.
Error Message Error: Minimum Bandwidth format is invalid.
Explanation User try to configure Minimum Bandwidth with non-numeric
characters.
Recommended Action Use numeric characters for Minimum Bandwidth.
Error Message Error: Value (<value>) is invalid for Minimum Bandwidth. Valid
range is 0 to 100 in increments of 5.
Explanation The value of Minimum Bandwidth is out of range.
Recommended Action The range of the Minimum Bandwidth is 0 to 100 in increments
of 5.
To Next Page
Loading...
