Fujitsu PRIMERGY BX900 - DOT1 X Messages

© 2011 Fujitsu Technology Solutions
2.10 DOT1X Messages
This section contains the DOT1X module messages.
Severity Level 6
Error Message dot1xSave: Error on call to sysapiCfgFileWrite for config file
<Dot1x Config File Name>
Explanation Failed saveing dot1x configuration.
Recommended Action The config file is corrupt and use the factory default intead
Severity Level 6
Error Message dot1xApiCnfgrCommand: Failed calling dot1xIssueCmd.
Explanation Failed calling dot1xIssueCmd.
Recommended Action The calling dot1IssueCmd is invalid.
Severity Level 6
Error Message dot1xInit: msgQueue creation error.
Explanation Message queue creation error when system initialization for
dot1x component.
Recommended Action The dox1 mdoule is failed to init.
Severity Level 6
Error Message Failed to initialize dot1x outcalls
Explanation Failed to inialize dot1x outcalls when the configurator control
commands/request pair init phase I.
Recommended Action The dox1 mdoule is failed to init.
Severity Level 6
Error Message Unable to create dot1xTrace block
Explanation Unable to create dot1xTrace block when the configurator control
commands/request pair init phase I.* Trace create for
debugging. This trace has 256 entries, each entry is 16 byte
long. Actual user data available is 15 bytes as the first byte
always records the trace id
Recommended Action The dox1 mdoule is failed to init.
Severity Level 6
Error Message Failed to enabling dot1x tracing
Explanation Failed to enabling dot1x tracing when the configurator control
commands/request pair init phase 1.
Recommended Action The dox1 mdoule is failed to init.