© 2011 Fujitsu Technology Solutions
4.6 Stacking
This section contains the Unit Config messages.
Error Message Error: Value <switch#> is out of range for Switch ID. The valid
range is 1 to 8.
Explanation The value of Switch ID is not numeric character or out of range 1
to 8.
Recommended Action The value of field should be in range 1 to 8.
Error Message Error: Failed to set Priority.
Explanation The value of Priority is failed to set.
The swith you set might be not present in the stack.
Recommended Action Please check the switch is already in the stack.
You can not set the Priority of the provision switch which is not
being in the stack.
Error Message Error: Failed to create Switch ID.
Explanation The value of Switch ID is failed to create. The Switch ID might be
already exist.
Recommended Action Use a valid or unconfgiured Switch ID for the switch provision
function.
Error Message Stack management move not performed!
Explanation The target switch doe not exist or does not be ready for being a
stack master.
Recommended Action Check the status of target switch if it is in the “Ready” state.
To Next Page
Loading...
