Fujitsu PRIMERGY BX900 - Dhcp

© 2011 Fujitsu Technology Solutions
3.1.12 DHCP
This section contains the DHCP Client.
Error Message Incorrect input! Use 'ip dhcp client-identifier {text <text> | hex
<hex> }'
Explanation User input incomplete command .
Recommended Action Use 'ip dhcp client-identifier {text <text> | hex <hex> }'
Error Message Incorrect input! Use 'ip dhcp client-identifier hex
XX:XX:XX:XX:XX:XX'
Explanation User input invalid format of hex value.
Recommended Action Use 'ip dhcp client-identifier hex XX:XX:XX:XX:XX:XX'
Error Message Client identifier test must contain alphanumeric characters only.
Explanation User input invalid value for Client identifier.
Recommended Action Input text string. (Range: 1-32 characters)
Error Message Incorrect input! A text string. (Range: 1-32 characters)
Explanation User input over 32 characters for Client identifier.
Recommended Action Maximum 32 characters can be used for Client identifier.
Error Message Error! can't restart because the protocol of ipv6 dhcp6 client is
none.
Explanation User try to restart IPv6 DHCP client function, but the IPv6 DHCP
client function doesn’t enable.
Recommended Action Enable IPv6 DHCP client function on the switch interface.
(Config)#interface vlan 1
(if-vlan 1)#ipv6 address protocol dhcp6
Error Message Error! can't restart because the protocol of oob dhcp6 client is
none.
Explanation User try to restart IPv6 DHCP client function, but the IPv6 DHCP
client function doesn’t enable.
Recommended Action Enable IPv6 DHCP client function on the OOB interface.
(Config)#oob protocol dhcp6
Error Message
Error! 'oob protocol dhcp6 restart'.
Explanation Duplicate user input ' oob protocol dhcp6 restart '.
Recommended Action Use ‘oob protocol dhcp6 restart’.