© 2011 Fujitsu Technology Solutions
3.3 Group Administration (IBP)
3.3.1 Uplink Set
This section contains the Uplink-Set module messages.
Error Message Incorrect input! Use 'uplink-set <uplinkSetName>'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘uplink-set <uplinkSetName>'.
Error Message Incorrect input! Use 'no uplink-set <uplinkSetName>'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘no uplink-set <uplinkSetName>'.
Error Message Incorrect input! Uplink Set name can not more than 32
characters.
Explanation User input an Uplink set name, the length of name exceeded 32
characters.
Recommended Action The length of the Uplink set name should less than 32
characters.
Error Message Incorrect input! Uplink Set name must contain alphanumeric
characters only.
Explanation User input non alphanumeric characters for Uplink set name.
Recommended Action Use alphanumeric characters for the Uplink set name.
Error Message Incorrect input! Uplink Set <uplinkSetName> has been used!!
Explanation User try to create a new Uplink Set that has already exist in the
system.
Recommended Action Use the correct Uplink Set name for this function.
Error Message Incorrect input! Uplink Set <uplinkSetName> does not exist!!
Explanation User input an Uplink set name, but the Uplink set doesn’t exist.
Recommended Action Use the correct Uplink set name for this function.
Error Message ERROR: Uplink Set table is full.
Explanation User try to create a new Uplink Set, but the Uplink Set table has
reached the maximum.
To Next Page
Loading...
