Fujitsu PRIMERGY BX900 - Port-Channel

© 2011 Fujitsu Technology Solutions
3.2.12 Port-Channel
This section contains the Port-Channel module messages.
Error Message Incorrect input! Use 'load-balance
{dst-ip|dst-mac|src-dst-ip|src-dst-mac|src-ip|src-mac}'.
Explanation Incomplete command for this function.
Recommended Action Use complete command Use 'load-balance
{dst-ip|dst-mac|src-dst-ip|src-dst-mac|src-ip|src-mac}'.
Error Message Invalid interface <IntIfNum>, is not a port-channel interface.
Explanation The interface is not a port-channel interface.
Recommended Action Use correct port-channel interface.
Error Message Incorrect input! Use 'no port-channel load-balance all'.
Explanation Incomplete command for this function.
Recommended Action Use 'no port-channel load-balance all'.
Error Message Cannot change the auto-negotiate mode of a port-channel
member.
Explanation The port-channel member port can NOT be changed to
auto-negotiate mode .
Recommended Action Use this command only on normal port.
Error Message Could not create. Maximum number of port-channels (64)
reached.
Explanation User creates more than 64 port-channel groups.
Recommended Action User just can create maximum 64 port-channel groups.
Error Message Error: Characters in the port-channel name must be
alphanumeric and can contain dashes or underscores.
Explanation User input a port-channel name with non-alphanumeric
characters.
Recommended Action Use alphanumeric and dashes or underscores for port-channel
name.
Error Message No port-channels exist.
Explanation There is no port-channel exist.
Recommended Action Create a port-chnnel first.