© 2011 Fujitsu Technology Solutions
Error Message Ports cannot be added to disabled port-channels.
Explanation User attempt to add a member to a disabled port-channel.
Recommended Action Enable the port-channel before add member ports.
Error Message Ports being added to a port-channel must not be participating in
MAC Filtering.
Explanation User attempt to add a interface to a port-channel, but the
interface has been set with MAC filter function.
Recommended Action Use command ‘no macfilter addsrc <macaddr>’ to remove the
MAC Filter setting first, and then use command ‘channel-group
<unit/slot/port>’ to add interface to the port-channel.
Error Message Could not create. This port-channel name already exists.
Explanation User create a port-channel name that already exists.
Recommended Action Use another port-channel name.
Error Message [slot/port] is not a configured port-channel.
Explanation User try to display the port-channel information for
non-port-channel interface.
Recommended Action Use correct port-channel interface slot/port for this command.
Error Message Port-channel name must be less than 16 characters.
Explanation User attempt to crate a port-channel name is over 15 characters.
Recommended Action Configure port-channel name within 15 characters.
Error Message Incorrect input! Use 'port-channel load-balance all
{dst-ip|dst-mac|src-dst-ip|src-dst-mac|src-ip|src-mac}'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘port-channel load-balance all
{dst-ip|dst-mac|src-dst-ip|src-dst-mac|src-ip|src-mac}'.
Error Message Incorrect input! Use 'port-channel name {<logical slot/port> | all}
<name>'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘port-channel name {<logical slot/port> |
all} <name>'.
Error Message Port-channel name is too long.
Explanation User attempt to rename a port-channel name over 15
characters.
Recommended Action Configure port-channel name within 15 characters.
To Next Page
Loading...
