Fujitsu PRIMERGY BX900 - Service LAN

© 2011 Fujitsu Technology Solutions
3.3.4 Service LAN
This section contains the Service LAN module messages.
Error Message Incorrect input! Use 'svc-lan <svcLanName> <vlanID>
<uplinkSetName>'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘svc-lan <svcLanName> <vlanID>
<uplinkSetName>'.
Error Message Incorrect input! Use 'no svc-lan <svcLanName>'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘no svc-lan <svcLanName>'.
Error Message Incorrect input! Service LAN name can not more than 32
characters.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘
Error Message Incorrect input! Service LAN name must contain alphanumeric
characters only.
Explanation User input non alphanumeric characters for Service LAN name.
Recommended Action Use alphanumeric characters for the Service LAN name.
Error Message Incorrect input! Service LAN <svcLanName> has been used!!
Explanation User try to create a new Service LAN that has already exist in
the system.
Recommended Action Use the correct Service LAN name for this function.
Error Message Incorrect input! Service LAN <svcLanName> does not exist!
Explanation User input an Service LAN name, but the Service LAN doesn’t
exist.
Recommended Action Use the correct Service LAN name for this function.
Error Message ERROR: Service LAN table is full.
Explanation User try to create a new Service LAN, but the Service LAN table
has reached the maximum.
Recommended Action The maximum Service LAN is 10, please check the Service LAN
setting.