© 2011 Fujitsu Technology Solutions
3.3.6 Lock
This section contains the Lock module messages.
Error Message Incorrect input! Use 'lock <lock_identifier> [EXCLUSIVE]'.
Explanation User input incorrect command.
Recommended Action Use 'lock <lock_identifier> [EXCLUSIVE]'.
Error Message Incorrect input! Use 'no lock {<lock_identifier>|all}'.
Explanation User input incorrect command.
Recommended Action Use 'no lock {<lock_identifier>|all}'.
Error Message Incorrect input! Lock identifier can not more than %d characters.
Explanation User input incorrect command.
Recommended Action Lock identifier can not more than 32 characters.
Error Message Incorrect input! Lock identifier must contain alphanumeric
characters only.
Explanation The input lock identifier contains non-alphanumeric characters.
Recommended Action lock identifier must contain alphanumeric characters only.
Error Message Incorrect input! Lock identifier <identifier> has been used!
Explanation User input Lock identifier has been used.
Recommended Action Use other lock identifier.
Error Message Lock identifier can not be 'ALL'.
Explanation User input Lock identifier used ALL.
Recommended Action Lock identifier can not be 'ALL'.
Error Message Lock identifier entry is full!!
Explanation User input Lock identifier is full.
Recommended Action Lock identifier entry is full!!
Error Message Incorrect input! Lock identifier <identifier> does not exist!!
Explanation Users delete Lock identifier which does not exist.
Recommended Action Use correct lock identifier for this function.
To Next Page
Loading...
