Fujitsu PRIMERGY BX900 - Service LAN

© 2011 Fujitsu Technology Solutions
4.3.4 Service LAN
This section contains the Service LAN module messages.
Error Message Error: Failed to set <svcLanName>. Service LAN name must
contain alphaNumeric characters only, and can't be empty.
Explanation It is failed to create a Service LAN Group while the name is not
alphanumeric characters.
Recommended Action Use alphanumeric characters for the Service LAN Group name
to create a Service LAN Group and the name can not be empty.
Error Message Error: Can't set the same VLAN ID on uplink set
<uplinkSetName>.
Explanation The Service LAN Group can’t use this VLAN ID which is used by
on group with the same uplink set.
Recommended Action Use the different VLAN ID for Service LAN Group.
Error Message Error: Failed to delete <svcLanName>.
Explanation The Service LAN name is invalid.
Recommended Action Refresh the WEB page, and select the service LAN name again.
Error Message Error: Failed to create Service LAN. Service LAN already exists.
Explanation The Service LAN already existed.
Recommended Action Create the Service LAN with a name which is not used in the
system.
Error Message Error: Value <vlanId> is out of range for VLAN ID. The valid
range is 1 to 4094.
Explanation The input VLAN ID of Service LAN is out of range.
Recommended Action Set VLAN ID of Service LAN with numeric character 1 to 4094.
Error Message Error: Uplink set <uplinkSetName> is used by other module.
Explanation The Uplink set is already used by other module.
Recommended Action Remove the Uplink set from the used module or set other Uplink
for Service LAN.
Error Message Error: Interface <interface_identifier> has been used.
Explanation The interface is already used by other Group.
Recommended Action Remove the interface from the other Group or set other interface
to Service LAN.