© 2011 Fujitsu Technology Solutions
3.3.11 Port-backup
This section contains the Port-backup module messages.
Error Message Incorrect input! Use 'port-backup <uplinkSetName>
[failback-time <value>]'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘port-backup <uplinkSetName>
[failback-time <value>]'.
Error Message Incorrect input! Use 'no port-backup <uplinkSetName>
[failback-time]'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘no port-backup <uplinkSetName>
[failback-time]'.
Error Message Incorrect input! Use 'show port-backup [<uplinkSetName>
[status] | status ] '.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘show port-backup [<uplinkSetName>
[status] | status ] '.
Error Message ERROR: Could not set internal port '%s' on Port Backup port.
Explanation User try to add an internal port to the backup port.
Recommended Action Internal port doesn’t support the Port Backup function.
Error Message Error: It is not allowed to configure the last member of active port
to backup port !!
Explanation User try to change the last active port to backup port.
Recommended Action The Uplink set should have at least one active port; user can’t
change all member ports to the backup ports.
Error Message Set Uplink Set '%s' backup failure!!
Explanation User try to add an interface to backup port, but the interface is
not belong to any Uplink set. Or the interface is a logical
interface not a physical interface.
Recommended Action Use a physical interface that has added to Uplink set for this
function.
To Next Page
Loading...
