Fujitsu PRIMERGY BX900 - Udld

© 2011 Fujitsu Technology Solutions
3.1.10 UDLD
This section contains the UDLD messages.
Error Message Incorrect input! Use 'show udld {<slot/port>}'.
Explanation User input incomplete command .
Recommended Action Use 'show udld {<slot/port>}'.
Error Message Error! UDLD can only be configured on physical interface.
Explanation User attempt to configure/show udld on invalid interfaces.
Recommended Action Make sure the interface is not port-channel interface.
Error Message Incorrect input! Use 'udld aggressive'.
Explanation User input incomplete command .
Recommended Action Use '’udld aggressive’.
Error Message Incorrect input! Use 'udld enable'.
Explanation User input incomplete command .
Recommended Action Use 'udld enable’.
Error Message Incorrect input! Use 'udld message time <7-90>'.
Explanation User input incomplete command .
Recommended Action Use 'udld message time <7-90>'.
Error Message Error! Input a value in the range of <7-90> seconds.
Explanation User input a value out of range <7-90> seconds for udld
message time.
Recommended Action Input a value in the range of <7-90>
Error Message Incorrect input! Use 'udld port aggressive'.
Explanation User input incomplete command .
Recommended Action Use '’udld port aggressive’.
Error Message Incorrect input! Use 'udld port'.
Explanation User input incomplete command .
Recommended Action Use 'udld port