© 2011 Fujitsu Technology Solutions
2.9 COS Messages
This section contains the COS module messages.
Severity Level 6
Error Message <routine_name>: Unable to apply saved config -- using factory
defaults instead
Explanation Unable to apply saved config
Recommended Action The file is corrupt and reset the factory default instead
Severity Level 6
Error Message <routine_name>: Cannot obtain default traffic class mapping for
IP Prec <L7_QOS_COS_MAP_NUM_IPPREC>, intf <intIfNum>
Explanation Cannot obtain default traffic class mapping for IP Prec
Recommended Action The setting config may be error.
Severity Level 6
Error Message <routine_name>: Cannot obtain default traffic class mapping for
IP DSCP <L7_QOS_COS_MAP_NUM_IPDSCP>, intf
<intIfNum>
Explanation Cannot obtain default traffic class mapping for IP DSCP
Recommended Action The setting config may be error.
Severity Level 6
Error Message <routine_name>: Global COS mapping table config is no longer
valid
Explanation Global COS mapping table config is no longer valid
Recommended Action The COS value is invalid for the system
Severity Level 6
Error Message <routine_name>: Failed applying config data to interface
<intIfNum>
Explanation Failed applying config data to interface
Recommended Action The interface number is invalid for the system.
Severity Level 6
Error Message <routine_name>: Failed applying COS map table config data to
interface <intIfNum>
Explanation Failed applying COS map table config data to interface
Recommended Action COS map table config to set to fail
To Next Page
Loading...
