Fujitsu PRIMERGY BX900 - Cdp

© 2011 Fujitsu Technology Solutions
3.1.9 CDP
This section contains the CDP Config messages.
Error Message Incorrect input! Use 'cdp run all'
Explanation User input incomplete command.
Recommended Action Use 'cdp run all'
Error Message Incorrect input! Use 'no cdp run all'
Explanation User input incomplete command.
Recommended Action Use 'no cdp run all'
Error Message Incorrect input! Use 'cdp timer <5-254>'
Explanation User input incomplete command.
Recommended Action Use 'cdp timer <5-254>'
Error Message Incorrect input! Use 'cdp holdtime <10-255>'
Explanation User input incomplete command.
Recommended Action Use 'cdp holdtime <10-255>'
Error Message CDP is only supported on physical ports.
Explanation User attempt to enable CDP on logical ports.
Recommended Action CDP can only be enabled on physical ports.