Fujitsu PRIMERGY BX900 - Diffserv Messages

© 2011 Fujitsu Technology Solutions
2.8 DiffServ Messages
This section contains DiffServ module messages.
Severity Level 6
Error Message No DiffServ policy applied on port <bcmx_lport>
Explanation No DiffServ policy applied on port
Recommended Action The port nimber is not matched the Diffserv poicy.
Severity Level 6
Error Message DiffServ not removed from port <bcmx_lport>
Explanation DiffServ not removed from port
Recommended Action The port nimber is not matched the Diffserv poicy.
Severity Level 6
Error Message routine_name: Error activating saved config for intIfNum
<intIfNum> -- using factory defaults instead
Explanation Error activating saved config
Recommended Action The Diffserv Config file is corrupt.
Severity Level 6
Error Message routine_name: Error activating saved config for intIfNum
<intIfNum> -- attempt to use factory defaults also failed
Explanation Error activating saved config
Recommended Action The Diffserv Config file is corrupt.
Severity Level 6
Error Message routine_name: Error deleting service interface <intIfNum>
<Direction>
Explanation Error deleting service interface
Recommended Action The interface port is not matched the diffserv service
Severity Level 6
Error Message routine_name: Error during callback processing for intf
<intIfNum> , event <event>
Explanation Error during callback processing
Recommended Action The system is failed to init to the Diffserv Service.