Fujitsu PRIMERGY BX900 - Port-Group

© 2011 Fujitsu Technology Solutions
3.3.2 Port-Group
This section contains the Port-Group module messages.
Error Message Incorrect input! Use 'port-group <portGroupName>
[<uplinkSetName>]'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘port-group <portGroupName>
[<uplinkSetName>]'.
Error Message Incorrect input! Use 'no port-group <portGroupName>'.
Explanation Incomplete command for this function.
Recommended Action Use complete command ‘no port-group <portGroupName>'.
Error Message Incorrect input! Port Group name can not more than 32
characters.
Explanation User input a Port Group name, the length of name exceeded 32
characters.
Recommended Action The length of the Port Group name should less than 32
characters.
Error Message Incorrect input! Port Group name must contain alphanumeric
characters only.
Explanation User input non alphanumeric characters for Port Group name.
Recommended Action Use alphanumeric characters for the Port Group name.
Error Message Incorrect input! Port Group <portGroupName> has been used!!
Explanation User try to create a new Port Group that has already exist in the
system.
Recommended Action Use the correct Port Group name for this function.
Error Message Incorrect input! Port Group <portGroupName> does not exist!!
Explanation User input a Port Group name, but the Port Group doesn’t exist.
Recommended Action Use the correct Port Group name for this function.
Error Message ERROR: Port Group table is full.
Explanation User try to create a new Port Group, but the Port Group table
has reached the maximum.
Recommended Action The maximum Port Group is 36, please check the Port Group
setting.