© 2011 Fujitsu Technology Solutions
4.2.2 Port
This section contains the port module messages.
Error Message Error: Failed to set STP Mode.
Explanation User try to change the STP mode of the interface, but the
interface doesn't exist in the system.
Recommended Action Refresh the WEB page, and select the interface again.
Error Message Error: Failed to set Capability.
Explanation User try to change the speed Capability of the interface, but the
interface doesn't exist in the system.
Recommended Action Refresh the WEB page, and select the interface again.
Error Message Error: Failed to set Physical Mode.
Explanation User try to change the Physical mode of the interface, but the
interface doesn't exist in the system.
Recommended Action Refresh the WEB page, and select the interface again
Error Message Error: Failed to set LACP Mode <interface identifier>.
Explanation User try to change the LACP mode of the interface, but the
interface doesn't exist in the system.
Recommended Action Refresh the WEB page, and select the interface again.
Error Message Error: Failed to set Link Trap.
Explanation User try to change the Link Trap of the interface, but the interface
doesn't exist in the system.
Recommended Action Refresh the WEB page, and select the interface again.
Error Message Error: Failed to set Admin Mode.
Explanation User try to change the Admin Mode of the interface, but the
interface doesn't exist in the system.
Recommended Action Refresh the WEB page, and select the interface again.
To Next Page
Loading...
