Fujitsu PRIMERGY BX900 - Page 343

© 2011 Fujitsu Technology Solutions
Error Message Error: Failed to set Admin Mode. Interface <interface identifier>
was disabled by e-keying function.
Explanation User try to enable a interface, but it is failed. The interface is
disabled by the e-Keying function.
Recommended Action Check the e-Keying status of this interface first. User does not
allow to enable it while the e-Keying status is disabled.
To enable the e-Keying, please refer to the MMB operations.
Error Message Error: Failed to set Admin Mode. This function is not allowed on
port-channel members <interface identifier>.
Explanation User try to set Admin Mode on a prot-channel member, and it is
failed.
Recommended Action To set the Admin Mode from the port-channel interface.
Error Message Error: Failed to set Port Description.
Explanation User try to change the Port Description of the interface, but the
interface doesn't exist in the system.
Recommended Action Refresh the WEB page, and select the interface again.
Error Message Error: Maximum Frame Size format is invalid.
Explanation The value of Port Maximum Frame Size is out of range.
Recommended Action Set Port Maximum Frame Size with numeric value from 1518 to
9216.
Error Message Error: Value (<value>) is out of range for Maximum Frame Size.
The valid range is 1518 to 9216.
Explanation The value of Port Maximum Frame Size is out of range.
Recommended Action Set Port Maximum Frame Size with numeric value from 1518 to
9216.
Error Message Error: Failed to set STP Loop Guard Mode.
Explanation User try to change the STP Loop Guard Mode of the interface,
but the interface doesn't exist in the system.
Recommended Action Refresh the WEB page, and select the interface again.
Error Message Error: Failed to set STP Root Guard Mode.
Explanation User try to change the STP Root Guard Mode of the interface,
but the interface doesn't exist in the system.
Recommended Action Refresh the WEB page, and select the interface again.