Fujitsu PRIMERGY BX900 - Err-Disable Recovery; MAC Bucket Overflow

© 2011 Fujitsu Technology Solutions
2.37 Err-Disable Recovery
Severity Level 6
Error Message <Cause> error detected on <intIfNum>, putting <intIfNum> to
err-disable state."
Explanation There is an error detected on <intIfNum> by <Cause> and
<intIfNum> is shutdown.
Recommended Action Check and remove the cause. Use ‘no shutdown’ to enable
<intIfNum>. Or use errdisable recovery timer to enable it.
Severity Level 6
Error Message <intIfNum> is binging out of err-disable state.
Explanation <intIfNum> is enabled again by the errdisable recovery timer.
Recommended Action Check and remove the cause.
2.38 MAC Bucket Overflow
Severity Level 6
Error Message MAC Address Bucket OverFlow entry learned on <intIfNum>
(MAC : <MacAddr>, VLAN : <vlanId>).
Explanation The MAC address <MACAddr> has bucket overflow, and it is
learned by EHM on <intIfNum>.
Recommended Action The MAC address bucket overflowed and can’t be inserted into
the L2 table.
Severity Level 6
Error Message Maximum MAC Address Bucket OverFlow entry reached on
<intIfNum> (MAC : <MacAddr>, VLAN : <vlanId>)."
Explanation The maximum support overflowed MAC address is reached. The
MAC address <MacAddr> can’t be learned by EHM on
<intIfNum>.
Recommended Action The MAC address bucket overflowed and can’t be inserted into
the L2 table. The maximum support overflowed MAC address is
25 per interface. Suggest to move this MAC address to other
chasiss.