Fujitsu PRIMERGY BX900 - Page 234

© 2011 Fujitsu Technology Solutions
Error Message Incorrect input! VLAN port group <vlanGroupName> does not
exist!
Explanation User input a VLAN port group name, but the VLAN port group
doesn’t exist.
Recommended Action Use the correct VLAN port group name for this function.
Error Message ERROR: Can't set VLAN port group with the same VLAN ID
<vlanId> on the <vlanGroupName>.
Explanation Can't set VLAN port group with the same VLAN ID used by a
exist VLAN port group.
Recommended Action Use other VLAN ID for your VLAN port group.
Error Message Uplink Set <uplinkSetName> has been used by other module."
Explanation This Uplink Set has been used by other module."
Recommended Action Use other uplink set for your group.
Error Message Incorrect input ! VLAN port group <vlanGroupName> has been
used!!
Explanation VLAN port group name has been used!!
Recommended Action Use other group name for your VLAN port group.
Error Message ERROR: VLAN port group table is full.
Explanation User try to create a new VLAN port group, but the VLAN port
group table has reached the maximum.
Recommended Action The maximum VLAN port group is 30, please check the VLAN
port group setting.
Error Message Incorrect input! Use 'vlan-group-nativeVLAN
<vlanGroupName>'.
Explanation User input incorrect command.
Recommended Action .Use 'vlan-group-nativeVLAN <vlanGroupName>'.
Error Message Incorrect input! Use 'no vlan-group-nativeVLAN
<vlanGroupName>'.
Explanation User input incorrect command.
Recommended Action Use 'no vlan-group-nativeVLAN <vlanGroupName>'.