Fujitsu PRIMERGY BX900 - Page 244

© 2011 Fujitsu Technology Solutions
Error Message ERROR: syntax error, command: no switchport multicast all
Explanation User input incomplete command .
Recommended Action Use command ‘no switchport multicast all’
Error Message Incorrect input! Use 'port-monitor session <session-id> {mode |
source interface <slot/port> [tx | rx] | destination interface <slo
t/port> }'.
Explanation User input incomplete command.
Recommended Action Use 'port-monitor session <session-id> {mode | source interface
<slot/port> [tx | rx] | destination interface <slo
t/port> }'.
Error Message Incorrect input! Use 'no monitor [session <session-id> [{mode |
source interface <slot/port> | destination interface}]]'.
Explanation User input incomplete command.
Recommended Action Use 'no monitor [session <session-id> [{mode | source interface
<slot/port> | destination interface}]]'.
Error Message This interface can not be configured as destination port.
Explanation User attempt to set the port-channel interface to be destination
port.
Recommended Action User can only set the normal ports to be destination port.
Error Message Probe port must be reset before re-configuring it.
Explanation User attempt to change the destination port.
Recommended Action User must delete the original destination port and then set a new
one.
Error Message Interface is not configured.
Explanation User attempt to delete the destination port but it was not created.
Recommended Action Make sure the destination had been created.