Fujitsu PRIMERGY BX900 - Page 25

© 2011 Fujitsu Technology Solutions
Severity Level 6
Error Message Config FILENAME is not separated from FILENAME as we don’t
need.
Explanation Unconbined configuration file is failed to separate.
Recommended Action The configuration file is wrong and need to be checked.
Severity Level 6
Error Message WDT Function init OK.
Explanation The watch dog timer is initialized successfully.
Recommended Action Watch dog timer is started by system.
Severity Level 6
Error Message ECC Error Detect Function init OK.
Explanation The ECC error detect task is initialized successfully.
Recommended Action The ECC error detect task is started by system.
Severity Level 6
Error Message ECC Error Detect Function init FAIL.
Explanation The initialization of ECC error detect task is failed.
Recommended Action Reboot the switch again.
Severity Level 6
Error Message Single-bit ECC error (0x%08x), interrupt counter = %d, capture
addr = 0x%08x
Explanation A single-bit ECC error is detected on <addr>.
Recommended Action There is a single-bit ECC error is detected. If it is possible, user
is recommended to replace the DDR-RAM module from switch.
Severity Level 6
Error Message Link Up: Unit: <unitId> Slot: <slotId> Port: <portNo>
Explanation The interface unit/slot/port is link up.
Recommended Action
Severity Level 6
Error Message Link Down: Unit: <unitId> Slot: <slotId> Port: <portNo>
Explanation The interface unit/slot/port is link down.
Recommended Action