Fujitsu PRIMERGY BX900 - Page 356

© 2011 Fujitsu Technology Solutions
Error Message Error: VLAN ID format is invalid.
Explanation The value of IGMP Snooping Querier VLAN ID is not numeric
character.
Recommended Action Set IGMP Snooping Querier VLAN ID with numeric character 1
to 4094.
Error Message Error: Value (<value>) is out of range for Vlan ID. The valid
range is 1 to 4094.
Explanation The value of IGMP Snooping Querier VLAN ID is out of range.
Recommended Action Set IGMP Snooping Querier VLAN ID with numeric character 1
to 4094.
Error Message Error:IGMP ADMIN must be enabled.
Explanation IGMP ADMIN is not enabled.
Recommended Action IGMP ADMIN must be enabled before configuring the setting.
Error Message Error: There are no ports assignment.
Explanation There are no ports assigned to IGMP Multicast Static Group.
Recommended Action Assign ports to IGMP Multicast Static Group.
Error Message Error: You cannot define L2Mcast Group for these MAC
addresses from 01:00:5E:00:00:00 to 01:00:5E:00:00:FF
Explanation The reserved Multicast MAC addresses can not be set for IGMP
Multicast Static Group.
Recommended Action Create IGMP Multicast Static Group with non-reserved Multicast
MAC address.
Error Message Error: MAC Address requires a MAC address in form
01:00:5e:xx:xx:xx.
Explanation User input an invalid format or non-multicast MAC address for
IGMP Multicast Static Group setting.
Recommended Action Use the correct multicast MAC address for this function, MAC
address should be in 01:00:5e:xx:xx:xx format where range for x
is 0 - F.
Error Message Error: Failed to create MAC Filter.
ERROR: Filter already exists.
Explanation User create a IGMP Multicast Static Group, but the MAC
address is already configured in the system.
Recommended Action Use another multicast MAC address to create the new IGMP
Static Group.