EasyManua.ls Logo

Fujitsu PRIMERGY BX900 - Page 365

Fujitsu PRIMERGY BX900
430 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© 2011 Fujitsu Technology Solutions
Error Message Error: Failed to delete Port Channel. This port channel is
configured as link state upstream.
Explanation The port-channel configured as upstream of a link state group
can not be deleted.
Recommended Action Remove the port-channel from link state group first.
Error Message Error: Failed to set Port Channel. Interface:
<interface_identifier> is configured as link state down stream.
Explanation The interface attached to link state downstream can not be set to
be the member of a port channel.
Recommended Action Remove the interface from link state group before adding it to a
port-channel or attach other interface to the port-channel.
Error Message Error: Failed to set Port Channel. Interface:
<interface_identifier> is configured as link state up stream.
Explanation The interface attached to link state upstream can not be set to be
the member of a port channel.
Recommended Action Remove the interface from link state group before adding it to a
port-channel or attach other interface to the port-channel.
Error Message Error: Failed to set Port Channel. Interface:
<interface_identifier> is configured as port backup.
Explanation The interface attached to port backup group can not be set to be
the member of a port-channel.
Recommended Action Remove the interface from port backup group before adding it to
a port-channel or attach other interface to the port-channel.
Error Message Error: Failed to set Member Ports. LACP Mode must be enabled
on member ports before they can be added to a Port Channel.
Explanation The interface can not be added to a port-channel if the LACP
Mode is disabled on this interface.
Recommended Action Enable the interface LACP Mode before adding it to a
port-channel.
Error Message Error: Failed to create Port Channel Members : Full-duplex is
needed.
Explanation The interface can not be added to a port-channel if half-duplex
Mode is set or operated on this interface.
Recommended Action Set the interface to operate at Full-duplex Mode before adding it
to a port-channel.

Table of Contents

Other manuals for Fujitsu PRIMERGY BX900

Related product manuals