Fujitsu PRIMERGY BX900 - Page 80

© 2011 Fujitsu Technology Solutions
Severity Level 6
Error Message Failure sending sFlow configurator init message.
Explanation There is something wrong while the initialization of sFlow.
Recommended Action Provide the message logs to your service provider for further
analysis.
Severity Level 6
Error Message sFlowTask(): Internal event msg receive failed
Explanation The internal event queue for receiving event message is full.
Recommended Action Event queue is full.
Severity Level 6
Error Message sFlowIntfChangeCallback: Received an interface change
callback while not ready to receive it
Explanation Failure setting the sflow for an interface
Recommended Action The sflow module is failed to init.
Severity Level 6
Error Message sflowTimerExpiryHdlr(): Sflow timer tick send failed
Explanation Failed to send timer event to message queue.
Recommended Action Timer queue is full.
Severity Level 6
Error Message sFlowReceiverSampleDatagramHeaderWrite: IPv4 agent
address get failed
Explanation Failed to get the IPv4 address of the sflow receiver
Recommended Action To check if switch blade has been configured with IPv4 address.
Severity Level 6
Error Message sFlowReceiverSampleDatagramHeaderWrite: IPv6 agent
address get failed
Explanation Failed to get the IPv6 address of the sflow agent.
Recommended Action To check if switch blade has been configured with the IPv6
address.