▶
Open the Server Management page.
▶
In the Boot W
atchdog group, check the
Enable Boot Watchdog option.
The Enable Boot Watchdog option must be selected.
▶
Select Reset from the Watchdog Action list.
▶
Click Apply for the changes to take effect.
For more information on iRMC settings, see the iRMC user guides.
5.3.9 Enabling replaced components in the BIOS
When a CPU, an expansion card, or a memory module fails, the defective
component will be set to Disabled or Failed in the BIOS. The server will then
reboot with only the intact hardware components remaining in the system
configuration. After replacing the defective component, it needs to be
reenabled in the BIOS.
▶
Enter the BIOS.
▶
Select the Advanced menu.
▶
Select the status menu of the desired component:
▶
Select CPU Status for CPUs.
This option is only available for multi-processor systems.
▶
Select Memory Status for memory modules.
▶
Select PCI Status
for expansion cards.
▶
Reset replaced components to Enable.
▶
Save your changes and exit the BIOS.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
Basic software procedures
TX1330 M4 Upgrade and Maintenance Manual 115
To Next Page
Loading...
