▶
"Switching on the server" on page 81
.
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the message
CPU has been changed.
This only indicates that the CPU configuration has been altered. There
is no technical problem.
Proceed as follows:
●
Restart your server.
●
As soon as the startup screen appears, press the
[F2] function key to
enter the BIOS.
●
If a password is assigned, enter the password and press [Enter].
●
Select the Save & Exit menu.
●
Select Save Changes and Exit or Save Changes and Reset.
●
Verify that the Global Error indicator stops flashing.
▶
If applicable, "Updating or recovering the BIOS and iRMC S5" on page
103
.
▶
"Resetting the error status after replacing memory modules or CPUs" on
page 110.
▶
"Enabling replaced components in the BIOS" on page 115.
▶
"Resuming BitLocker functionality" on page 121.
11.4 Replacing the heat sink
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Processor (CPU)
TX1330 M4 Upgrade and Maintenance Manual 353
To Next Page
Loading...
