Checking the label
▶
If available, check the label on the controller. Beside the part number
, you
may find the WWN address.
Using an UEFI BIOS
▶
Enter the BIOS setup menu.
▶
Select the Advanced menu.
The addresses are displayed at the Advanced menu main page.
Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
5.3.16.4 Looking for the GUID address of an infiniband or Omni-Path
controller
There are several possible locations where these addresses can be found.
▶
Inform the customer about the new or changed GUID address.
Checking the label
▶
If available, check the label on the controller. Beside the part number
, you
may find the GUID address.
5.3.16.5 Looking for SAS addresses of SAS controllers for external
devices
There are several possible locations where these addresses can be found.
▶
Inform the customer about the new SAS address. The customer need the
new SAS address, especially when the server is connected to a Fujitsu
Storage ETERNUS system.
Basic software procedures
TX1330 M4 Upgrade and Maintenance Manual 125
To Next Page
Loading...
