▶
When using a RAID array, add the additional HDD to the RAID array
.
Configuring the RAID array, refer to the documentation of the RAID
controller, used in your configuration, see "Documentation overview"
on page 28.
Concluding steps
▶
If applicable, "Reassembling" on page 66
.
Please see your controller manual to configure the installed HDD.
7.4.4 Removing 3.5-inch HDD modules
Customer Replaceable
Unit (CRU)
Hardware: 5 minutes
Tools: Tool-less
Preliminary steps
▶
If the HDD module to be removed is combined into a RAID array, please
proceed as follows:
Hard disk drive (HDD) / solid state disk (SSD)
188 Upgrade and Maintenance Manual TX1330 M4
To Next Page
Loading...
