▶
Thread the cable tie through the eye (1).
▶
Pull the cable tie tight to secure the power cable (2).
The insulated connector cannot now be disconnected from the server
accidentally
.
Y
ou can loosen the cable tie by opening the small locking lever (2).
It will take about 60 seconds until the server can be powered on.
4.6.2 Connecting the power cord (hot-plug PSU)
CAUTION
The server automatically adjusts to a mains voltage in the range from
100 V - 240 V
.
▶
You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
▶
Connect the power cord to the PSU.
▶
Connect the mains connector to a grounded mains outlet in the in-house
power supply network.
▶
Ensure that the status indicator on the PSU is lit green, see "Indicator on
hot-plug PSU" on page
51
1.
You can secure the power cord with a cable clamp to ensure that the
power cord cannot be disconnected from the server by mistake. The
cable clamp is included in the accessories pack that is delivered
together with the server.
Basic hardware procedures
80 Upgrade and Maintenance Manual TX1330 M4
To Next Page
Loading...
