▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 120.
▶
"Updating expansion card firmware" on page 106
.
▶
"Resuming BitLocker functionality" on page 121.
▶
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
Configuration of network settings should be performed by the
customer. For more information, see
"Note on network settings
recovery" on page 308.
▶
If applicable, restore LAN teaming configurations, see "Configuring LAN
teaming" on page 128
.
9.5.4 Replacing a riser card
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page 45
.
▶
"Suspending BitLocker functionality" on page 99.
▶
"Shutting down the server" on page 47.
▶
"Disconnecting the power cord" on page 48.
▶
Remove all external cables from the expansion card installed in the riser
card slot.
▶
"Getting access to the component" on page 50.
▶
Remove the system fan module, see "Removing the system fan module" on
page 82.
Expansion cards and backup units
310 Upgrade and Maintenance Manual TX1330 M4
To Next Page
Loading...
