Fujitsu PRIMERGY TX1330 M4

▶
If applicable, remove the SAS expander board holder without disconnecting
cables, see "Removing the SAS expander board holder" on page 273
.
Position the SAS expander board holder on the HDD cages to get more
space.
▶
"Locating the defective component" on page 46.
▶
Remove all external cables from the expansion card to be replaced.
Removing an expansion card
▶
Remove the expansion card, see "Removing an expansion card" on
page 305.
▶
If applicable, "Removing an SFP+ transceiver module" on page 297.
▶
If the slot bracket on the defective expansion card is to be reused:
"Removing a slot bracket" on page 290.
Installing an expansion card
▶
If applicable, "Installing slot brackets" on page 289.
▶
If applicable, "Installing SFP+ transceiver modules" on page 291.
▶
Install the expansion card, see "Installing an expansion card" on page 299.
Concluding steps
▶
If applicable, install the SAS expander board holder, see "Installing the SAS
expander board holder " on page 271.
▶
Install the system fan module, see "Installing the system fan module" on
page 85.
▶
"Reassembling" on page 66.
▶
Connect all external cables to the replaced expansion card.
▶
"Connecting the power cord" on page 79.
▶
"Switching on the server" on page 81.
▶
"Enabling replaced components in the BIOS" on page 115.
▶
Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page 123.
Expansion cards and backup units
TX1330 M4 Upgrade and Maintenance Manual 309