▶
Insert all HDD modules, see "Installing a 3.5-inch HDD module" on
page 187.
Make sure that you reinstall the HDD module in the bay it was located
before the HDD backplane replacement.
▶
"Installing the SAS expander board" on page 268.
▶
"Installing the new system fan" on page
283.
▶
"Reassembling" on page 66.
▶
"Connecting the power cord" on page 79.
▶
"Switching on the server" on page 81.
7.4.7 Upgrading configuration from up to four to up to
eight 3.5-inch HDDs
Upgrade and Repair Unit
(URU)
Hardware: 20 minutes
Software: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
CAUTION
All data on all HDDs/SSDs in the array will be lost when deleting the
RAID array!
▶
Be sure to back up your data before deleting a RAID array.
▶
For more information, see the "ServerView Suite RAID
Management" user guide.
After installing or removing an additional backplane, never forget to
change the system information using the Chassis ID Prom Tool.
Preliminary steps
▶
"Suspending BitLocker functionality" on page 99.
▶
"Shutting down the server" on page
47.
▶
"Disconnecting the power cord" on page 48.
Hard disk drive (HDD) / solid state disk (SSD)
TX1330 M4 Upgrade and Maintenance Manual 203
To Next Page
Loading...
